e908_511912_0206_Sp6.book Seite 1 Freitag, 24.
e908_511912_0206_Sp6.book Seite 3 Freitag, 24. März 2006 2:56 14 908 B / 908 D / 908 B ew / 908 T ew These microphones are professional pre-polarised condenser microphones. An extended dynamic range and a well balanced frequency response deliver an outstanding signal quality with excellent projection and the lowest possible distortion. An excellent directivity across the whole frequency range enables the mics to handle the highest signal levels without feedback.
e908_511912_0206_Sp6.book Seite 4 Freitag, 24.
e908_511912_0206_Sp6.book Seite 5 Freitag, 24. März 2006 2:56 14 Positioning the microphone Wind instruments ( 908 B / Position 908 B ew / 908 T ew) Resulting sound Commentary Reduced ambient noise Use the MZH 908 B clamp to attach the microphone to the bell of the instrument. Clear, powerful sound Balanced, natural sound To reduce ambient noise (at the expense of the true “Saxophone sound”) direct the microphone into the bell (as illustrated).
e908_511912_0206_Sp6.book Seite 6 Freitag, 24. März 2006 2:56 14 Drums / Percussions ( 908 D) Position Resulting sound Commentary More fundamental, little overtones Position on the drum: 3–5 cm above the drumskin, directed towards the center of the drumskin, the fundamental to overtones ratio can be adjusted by changing the angle of the microphone. The most balanced results are obtained at an angle of 30–60°.
e908_511912_0206_Sp6.book Seite 7 Freitag, 24. März 2006 2:56 14 Attaching the drum clamp to the drum Drums / Percussions ( 908 D) Position 1 2 Commentary To attach the MZH 908 D drum clamp, snap it onto the rim of the drum as follows: Put the upper part of the clip (1) onto the rim and clip on by pushing down in a rotating action (2) until it clips into place.
e908_511912_0206_Sp6.book Seite 8 Freitag, 24. März 2006 2:56 14 Optimum positioning of the microphone The various adjustment possibilities of the MZH 908 D and MZH 908 B clamps together with the flexible gooseneck enable the microphone to be optimally positioned on the sound source (see arrows in the diagrams below).
e908_511912_0206_Sp6.book Seite 9 Freitag, 24.
e908_511912_0206_Sp6.book Seite 10 Freitag, 24. März 2006 2:56 14 Specifications 908 B / 908 D / 908 B ew / 908 T ew Transducer principle pre-polarised condenser microphone Frequency response 40–20,000 Hz Pick-up pattern cardioid Sensitivity 4.0 mV/Pa (free field, no load at 1 kHz) 0.56 mV/Pa ( 908 T ew) Nominal impedance 100 Ω (balanced)* Min. terminating impedance 2 kΩ* Max.
e908_511912_0206_Sp6.book Seite 11 Freitag, 24.
e908_511912_0206_Sp6.book Seite 12 Freitag, 24.
e908_511912_0206_Sp6.book Seite 13 Freitag, 24. März 2006 2:56 14 Manufacturer declarations Warranty 2 years Approval Sennheiser electronic GmbH & Co. KG declare that this device is in compliance with the applicable CE standards and regulations. Batteries or rechargeable batteries Please dispose of batteries or rechargeable batteries as special waste or return them to your specialist dealer.
e908_511912_0206_Sp6.book Seite 14 Freitag, 24.
e908_511912_0206_Sp6.book Seite 4 Freitag, 24. März 2006 2:56 14 Sennheiser electronic GmbH & Co. KG 30900 Wedemark, Germany Phone +49 (5130) 600 0 Fax +49 (5130) 600 300 www.sennheiser.com Printed in Germany Publ.