User Manual

31
Using the products
Level 1 Level 2 To ... See …
Audio
Settings
Low Cut filter out low-frequency noise page 32
Equalizer select a sound profile or manually
adjust the equalizer
page 32
De-Esser attenuate sibilants page 33
Auto Gain
Control
activate/deactivate the dynamic com-
pression
page 33
Effects Reset reset all audio settings to the factory
default settings
page 33
Audio Level fine-tune the receiver‘s output level page 34
Output Type adjust the receiver‘s output level to
match the input (mic or line) of the
connected device
page 34
Exit exit Level 2 and return to Level 1
System
Settings
Auto Lock activate/deactivate the automatic lock
mode
page 34
Mute Switch activates/deactivate the transmitter‘s
MUTE switch
page 35
Display
Brightness
change the brightness of the display
panel
page 35
Help display the QR codes for the help
functions
page 35
System Info display the firmware version and serial
number
page 36
Factory Reset reset the receiver to the factory default
settings
page 36
Exit exit Level 2 and return to Level 1
Network
Settings
Mode change the IP address assignment
mode
page 36
IP change the IP address page 36
Subnet change the subnet mask page 36
Gateway change the gateway address page 37
IPv6 display the IPv6 address page 37
MAC display the MAC address page 37
Exit exit Level 2 and return to Level 1
Name – change the name of the radio link page 32
Walk
Test
– check the reception quality within the
operating environment
page 37
Exit – exit the operating menu and return to
the standard display