Instruction manual guidePORT 3200 system

Setting up a default project
8-10
 In the “Start ID of fixed Events” box, you can enter the limit between
fixed Events of location “0” and variable Events of locations “1” to
“63”.
The start ID of fixed Events is factory preset to “301”.
 In the “New project” dialog box, click “OK”.
The “Location configuration” dialog box opens (see “The “Location
configuration” dialog box” on page 8-24 and “Configuring a location”
on page 8-23).
Note:
For detailed information on how to set up projects, see “Configuring
the project (detailed description)” on page 8-15.
2. Configuring the cell
transmitter
 Make sure that the cell transmitter is connected to your computer and
turned on and that the software modules BSM and BSS are
running.
Either:
 In the “CT-ID/MTS” column of the “MTS parameters in cell transmitter”
table, double-click a table cell. Then click the button shown on the left
or press the F4 key.
 Under “Search in”, select the “Network environment\...\SYS”
folder and open the Tx000000.ini file of the cell transmitter.
 Confirm you entry by pressing the ENTER key or clicking an adjacent
table cell.
Note:
You can also create virtual Tx000000.ini files with any desired ID
numbers. This, for example, allows you to simulate a project and learn
about the operation of the software without hardware.
With such virtual ID numbers, you can also set up a project
independent of a certain location on a laptop to which no cell
transmitters are connected. Later you can replace the virtual cell
transmitters by the ones actually connected.
Please note, however, that your virtual ID numbers must not be
identical to the real ones! You should therefore use virtual ID numbers
which are lower than 100,000 (e.g. 000001, 000002, 000003 etc.).