Installation Manual

3/4"
1/4"
Wall Spacer (4 or 6)
Floor Guide (1)
Left & Right Stops (2)
Track (1)
Hanger (2)
#8 Floor Screw (2)
¼ Floor Anchor (2)
Hanger Bolt (4 or 6)
for Thicker Doors
Hanger Bolt w/ Cap
(4 or 6)
Anti-Jump Disc (2)
Allen Wrench (1)
5/16 Lag Bolt (4 or 6)
PREPARE THE DOOR
If using the Floor Guide, mortise a groove ¼” wide by ¾”
deep into the bottom center of door’s edge.
INSTALL HANGERS
(See back for 2000, 5000, & 6000 Series Drawings)
Position hangers on front center of stile (min. 2” from edge of door,
equal on each side
). Cut a piece of cardboard 2“ high and place
between the inner groove of the wheel and the top of the door to
correctly position the height of the hangers. For 1000, 2000, & 5000
Series, mark holes
& pre-drill 3/8” holes. Secure hangers. For 6000
Series, mark holes & secure hanger using screwdriver (do not drill.)
INSTALL HEADER BOARD
Do NOT install track directly onto drywall. Install a 1” x 4”
or 1” x 6” Header Board above the door opening directly
into studs. Header board must be solid wood and measure
at least the full legth of the track or longer.
INSTALL STOPS & TRACK
4a. Insert Stops on either side of track, inside the first & last hole.
4b. Position center of the track by measuring up from the floor
(door height + 1 ¾”). Align Spacers with holes in track. Use Lag
Bolts to install track into wood header & wall. Use wrench to
secure screws through spacers.
4
1
3
4a
4b
INCLUDED
COMPONENTS
BARN DOOR HARDWARE KIT
ASSEMBLY INSTRUCTIONS
* Optional Connector Plate available
if connecting multiple tracks.
TOOLS REQUIRED
1/4”
3/8”
* Header Board and
Anchoring Screws not
included in kit.
Center to Stile or
minimum of 2"
2"
2
drill out
3/8"