Specifications
Table Of Contents
- Safety instructions
- Intended use of the system
- Operating the EZL 2020-20 L charging case
- Servicing
- Symbols on adhesive labels attached to the EZL 2020-20 L charging case
- Attention! High Volume!
- Safety instructions for Li-poly and NiMH rechargeable batteries and batteries
- Additional safety instructions for the BA 2015 accupack and for batteries
- System components
- Overview of the system
- The operating controls
- SK 2020 D bodypack transmitter
- HDE 2020 D stethoset receiver
- EZL 2020-20 L charging case
- Indications and displays on the transmitter
- Indications and displays on the receiver
- Indications and displays on the charging case
- The functions of the transmitter operating controls
- The functions of the receiver operating controls
- The functions of the operating controls of the charging case
- Putting the components into operation
- Using the components
- The operating menu of the transmitter
- Care and maintenance
- If problems occur...
- Specifications
- Accessoires
- Manufacturer declarations
33
Using several Tourguide systems simultaneously
The Tourguide System 2020 D is supplied preset to six
selectable frequencies that will all work together with
each other. You can therefore have up to six separate
tours operating together in the same area.
All the supplied frequencies are intermodulation-free
and will work together.
However, we cannot guarantee freedom of inter-
ference from external sources – if you do experience
interference (and are using less than six systems
together) please try selecting a different preset
frequency.
Special transmitter settings
The following special settings can only be made via
the transmitter’s operating menu. An overview of the
transmitter’s operating menu is given from page 41
onwards.
Switching the line input on/off
You can connect an audio source such as a CD player,
MP3 player, etc. to the transmitter’s line input. If you
have connected an audio source, you then have to
switch on the line input as follows:
Press the SET button .
The operating menu appears and the first menu
“CHAN” flashes on the display.
Repeatedly press the / rocker button until
“LINE“ flashes on the display.
Press the SET button .
If the line input is switched off, “LINE.OFF“ flashes
on the display; if the line input is switched on,
“LINE.ON“ flashes on the display.
Press the / rocker button to change the
setting.