Specifications
Table Of Contents
- Safety instructions
- Intended use of the system
- Operating the EZL 2020-20 L charging case
- Servicing
- Symbols on adhesive labels attached to the EZL 2020-20 L charging case
- Attention! High Volume!
- Safety instructions for Li-poly and NiMH rechargeable batteries and batteries
- Additional safety instructions for the BA 2015 accupack and for batteries
- System components
- Overview of the system
- The operating controls
- SK 2020 D bodypack transmitter
- HDE 2020 D stethoset receiver
- EZL 2020-20 L charging case
- Indications and displays on the transmitter
- Indications and displays on the receiver
- Indications and displays on the charging case
- The functions of the transmitter operating controls
- The functions of the receiver operating controls
- The functions of the operating controls of the charging case
- Putting the components into operation
- Using the components
- The operating menu of the transmitter
- Care and maintenance
- If problems occur...
- Specifications
- Accessoires
- Manufacturer declarations
34
Press the SET button to permanently store the
setting.
“STORED” briefly appears on the display.
Adjust the sensitivity of the line input to match the
connected audio source as described in the
following section.
Changing the sensitivity of the line input
To adjust the sensitivity of the line input to match the
connected audio source:
Make sure that the line input is switched on (see
previous section).
Connect the external audio source, switch it on and
start playback.
Press the SET button .
The operating menu appears and the first menu
“CHAN” flashes on the display.
Repeatedly press the / rocker button until
“SENSIT“ flashes on the display and the LINE level
display appears.
Press the SET button .
The current input sensitivity and the LINE level
display appear on the display.
Press the / rocker button to change the
input sensitivity so that the LINE level display
shows full deflection during the loudest passages,
but the yellow LED PEAK never lights up.
Press the SET button to permanently store the
setting.
“STORED” briefly appears on the display, indicating
that the sensitivity of the line input has been
stored.
LINE
CH 03
MIC