Instruction manual

Connecting the optical microphone to the weather and windshield

왘 Remove the windshield basket and open the flap in the pipe as shown.

왘 Remove the protection caps from the connectors of the fiber optic cable .

왘 Push down the plastic housing on an even base until the housing detaches

from the connectors with an audible click.

Note:

Use a solid, even and clean base (e.g. a sheet of paper) in order to not

damage the tips of the connectors.

왘 Pull the connectors of the fiber optic cable  one after the other out of

the plastic housing.

왘 Remove the protection caps of the SCRJ-GOF socket inside the weather

and windshield.

왘 Observe correct polarity of the professionally ready-made cable, i.e. insert

the connectors of the fiber optic cable  into the SCRJ-GOF socket so that

the polarizing keys point outward. When the connectors are inserted

correctly, the polarizing keys lock into place with an audible click (see dia-

gram on page 9).

왘 Lay the remaining microphone cable around the microphone clamp.

Please note that fiber optic cable must not be bent like conventional cable.

Make sure not to bend it beyond a bend radius of 50 mm.

왘 Insert the optical microphone  into the microphone clamp .

쐋