Instruction manual

7
To connect the microphone:
왘 Use a suitable cable to connect the MZD 8000 to the micro-
phone input of a format converter or a mixing console.
왘 When connecting the cables, make sure that the connectors
are properly locked.
Remote controlling the MZD 8000
Via the AES 42 interface, you can make the following settings to
the MZD 8000.
Depending on the software or the format converter used, some
settings are possibly not supported.
For information on software updates, visit the Internet at
www.sennheiser.com.
Parameter Settings
Sampling rate 44.1/48/88.2/96/176.4/192 kHz
Analog pre-attenuation 0, –6, –12, –18 dB
Digital high-pass filter Off/40/80/160 Hz
Digital signal gain from 0 to 63 dB (in steps of 1 dB)
Test signal Mono: 1 kHz sine
Stereo: 1 kHz sine left and right
(phase of right channel is advanced)
Steps:
Off/–6 dBFS/–48 dBFS/–60 dBFS
Phase (polarity) 0, 180°
Mute On/off
MZD 8000_US.fm Seite 7 Freitag, 31. Oktober 2008 11:16 11