Instruction manual
Table Of Contents
- Important safety information
- The RS 165 digital wireless headphone system
- Package includes
- Product overview
- Putting the RS 165 into operation
- Setting up the transmitter
- Connecting the transmitter to an audio source
- Connecting the transmitter to an AC wall outlet
- Replacing and inserting the rechargeable batteries
- Charging the rechargeable batteries
- Adjusting the headband
- Using the RS 165 headphone system
- Switching your wireless headphone system on
- Adjusting the volume
- Muting/unmuting the headphones
- Activating/deactivating the dynamic bass boost
- Pairing headphones to the transmitter
- Switching your wireless headphones off
- Cleaning and maintaining the RS 165
- Troubleshooting
- Specifications
- Manufacturer declarations
Troubleshooting
RS 165
| 29
Leaving the range of the transmitter
The range of the transmitter largely depends on environmental conditions
such as wall thickness, wall composition etc. If the headphones leave the
range of the transmitter, the audio first cuts out occasionally until it finally
cuts out completely.
If you re-enter the transmission range within 5 minutes, the connection is
automatically re-established.
If you spend more than 5 minutes outside the transmission range, the
headphones switch off automatically.
Clearing the pair settings on the headphones
1 Press the Volume +/- buttons simultaneously and hold for 2 seconds.
The HDR status LED blinks red rapidly.
2 Press the HDR power button while continuously holding the Volume
+/- buttons. Release all 3 buttons.
The HDR status LED lights up green or red, depending on the battery
condition, and starts blinking slowly. The pair settings on the head-
phones are cleared.
BA
SS
1 2
BASS
BAS
S
B
ASS
2s