Instruction manual
Table Of Contents
- Important safety instructions
- Package contents
- Product overview
- Putting the RS 5000 into operation
- Setting up the transmitter
- Connecting the transmitter to an audio source
- Connecting the transmitter to the power supply system
- Charging the stethoset receiver’s rechargeable battery
- Displaying the remaining operating time of the rechargeable battery
- Using the charging reminder function
- Selecting and replacing the ear pads
- Using the RS 5000
- Cleaning and maintaining the RS 5000
- Using additional functions
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Using additional functions
RS 5000 | 33
Restoring the factory default settings
To restore the transmitter to the factory settings:
1 Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
2 Simultaneously press and hold the buttons L, and R.
3 Connect the transmitter to the power supply system by connect-
ing the connector of the power supply unit to the yellow socket
of the transmitter while keeping the 3 buttons pressed for at
least 3 seconds.
All LEDs on the transmitter flash. The transmitter settings are
restored to the factory settings.
To restore a stethoset receiver to the factory settings:
왘 Place the stethoset receiver into the transmitter’s charging com-
partment.
The
Receiver status
LED flashes green. The settings of the ste-
thoset receiver are also restored to the factory settings.
왘 Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
The factory settings are restored and you can use the wireless
headphone system again.
1
2
3
1
A
1
A
3s
+
1
A
If you place the stethoset receiver into the transmitter’s
charging compartment at the very beginning of the restore
procedure, the factory settings of the transmitter and the
receiver are restored simultaneously.