Operation Manual
3
FRESPTITNLJP DE EN
왘 Place the headphones on the charging cradle of the trans-
mitter. The red LED lights up, indicating that the batteries
are being charged. The LED remains lit even when the re-
chargeable batteries are fully charged.
Using the RS headphone system
4
Switching on the audio source
왘 Switch on the audio source. The transmitter automatically
switches on and off together with the audio source. The
ON/OFF LED lights up green.
5
Switching on the headphones/adjusting the volume
왘 First, set the volume on the headphones to a low level.
왘 Switch on the headphones and set the volume to the
desired level.
왘 Switch off the headphones after use to avoid discharging
the batteries.
6
Optimizing the reception
왘 Adjust the receiver channel with the TUNE control on the
headphones.
However, if reception is subject to interference:
왘 Change the transmission channel by setting the switch
at the bottom of the transmitter to another position and
re-adjust the receiver channel with the TUNE control on
the headphones. Some electronic devices (e.g. televisi-
ons) can cause interference to your wireless headphone
system. If this happens, increase the distance between
the transmitter and the interference source.
Specifications and
Frequently Asked Questions (FAQ’s)
왘 Visit our website at www.sennheiser.com.