user manual

Using the transmitter
15
To activate the RF signal:
To deactivate the RF signal on switch-on:
왘 See “offline operation” on page 13.
Monitoring the audio signal via headphones
왘 Set the headphone volume control  to the minimum position.
왘 Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output .
왘 Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Synchronizing transmitters and EK 2000 IEM receivers via the
infra-red interface
Synchronization allows you to quickly and easily transfer transmitter and receiver settings
from one device to the other, especially if you want to configure a multi-channel system.
There are two transfer directions:
1. Easy Setup Sync: Transfer from the receiver to one or several transmitters
Once you have performed a frequency preset scan with a receiver, you can use the Easy
Setup Sync function to transfer unused frequency presets from the receiver to the
transmitters via the infra-red interface. In order to set up a multi-channel system, you
use the diversity receiver to transfer the first unused channel from the selected
frequency bank to the first transmitter and the next unused channel to the second
transmitter and so on, thus ensuring that all transmitters of a multi-channel system
operate on suitable frequencies.
2. Sync: Transfer from a transmitter to a receiver
Once you have selected and set the desired receiver settings on the transmitter (either
manually or using the Easy Setup Sync function), you transfer these settings to a
receiver. This configures the receiver and establishes a transmission link between
transmitter and receiver.
왘 Press the jog dial.
The RF signal is deactivated. The transmission icon
 is not displayed. In addition,
the display backlighting changes from orange to red and “RF Mute” flashes in
alternation with the standard display.
왘 Press the STANDBY button.
“RF Mute Off?” appears on the display pane.
왘 Press the jog dial.
The RF signal is activated and the transmission icon
 is displayed. The display
backlighting changes from red to orange.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
왘 Set the headphone volume control  to the minimum position before putting the
headphones on.
왘 Do not continuously expose yourself to high volumes.
Stereo Transmitter SR 2000 IEM
PEAK
-10
0
-20
-30
-40
PEAK
-10
0
-20
-30
-40
AF I
AF II
 