Specifications

Soundbar SB01 Compliance Information
Bluetooth
Frequency band: 2400 – 2483.5 MHz
Transmit power: 10 mW (max)
WLAN/WiFi
Frequency band
(country-specific):
2400 – 2483.5 MHz
5170 – 5835 MHz
Transmit power: 100 mW (max)
Paper grammage: 70 gsm Guide delivery: open
Print colours: K (1C) Paper quality: woodfree
Open size: 210 x 297 mm Close size: --
Release date: Jan 21, 2019; MP
Print specs:
In compliance with | In Übereinstimmung mit | Conforme aux normes | Cumple con | Em conformidade com | In overeenstemming
met | In conformità a | Opfylder | Uppfyller | Seuraavia standardeja on sovellettu | Σε συμμόρφωση με τα εξής | Zgodnie z | Aşağıdaki
standartlara uyumludur | Изделие соответствует следующим стандартам | 次の基 準に準拠しています |
符合标准 | 符合下列法規 | 다음 요
건 준수 | Sesuai dengan:
Country/Region AMBEO Soundbar SB01
USA
FCC ID: DMOSB01
Contains FCC ID: 2AJYB-S810
FCC Part 15 B
Canada IC: 2099A-SB01
Contains IC: 20504-S810
CAN ICES-3 (B)/NMB-3(B)
Europe
Australia/New
Zealand
Japan
R
R
020-190004
018-170198
Contains transmitter module
Taiwan
R3A531
RoHS
CCAK18LP2560T0
CCAJ19LP0500T6
本產品內含模組
進口商：傑恩特國際有限公司
地址： 新北市23550中和區中正路637巷1號1樓
SENNHEISER
Model No:
FCC Supplier's Declaration of Conformity (SDoC)
We,
Sennheiser Electronic Corporation
One Enterprise Drive • Old Lyme •
CT 06371 • USA
Tel: [phone]
Fax: [phone]
declare the above device comply with the requirements of Federal Communications Commission.
This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
Responsible Party: Michael Lieske
SB01
Statements regarding FCC and Industry Canada
Déclaration requise par la FCC et l’Industrie Canada
This device complies with Part 15 of the FCC rules and RSSs of Industry Canada. Ope-
ration is subject to the following two conditions: 1) This device may not cause harmful
interference, and 2) This device must accept any interference received, including in-
terference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B di-
gital device, pursuant to part 15 of the FCC Rules and RSSs of Industry Canada. These
limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cau-
se harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interfe-
rence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Senn-
heiser electronic Corp. may void FCC authorization to operate this equipment.
Note: The country code selection is for non-US model only and is not available to
all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US
operation channels only.
Déclaration requise par la FCC et l’Industrie Canada
Cet appareil est conforme à la Partie 15 des réglementations de la FCC et à la norme
CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’uti-
lisation de l’appareil doit respecter les deux conditions suivantes : (1) L’appareil ne
doit pas produire d’interférences nuisibles, et, (2) il doit accepter toutes interférences
reçues, y compris celles qui pourraient avoir des effets non désirés sur son foncti-
onnement.
For Industry Canada / l’Industrie Canada
Caution :
• the device for operation in the band 5150-5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems;
• where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s)
necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth
in section 6.2.2.3 shall be clearly indicated.
Avertissement:
• les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés unique-
ment pour une utilisation à l’intérieur afin de réduire les risques de brouillage préju-
diciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
• lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modè-
le de l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme
à l’exigence de la p.i.r.e. applicable au masque d’élévation, énoncée à la section
6.2.2.3, doivent être clairement indiqués.
RF Radiation Exposure Information
This device meets FCC/ IC RF exposure guidelines for an uncontrolled environment.
Use of other accessories not verified by the manufacturer may not ensure compliance
with FCC / IC RF exposure guidelines. The equipment should be installed and opera-
ted with minimum distance 20 cm between the radiator and your body.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Déclaration d‘exposition aux radiations
Cet équipement est conforme aux limites d‘exposition aux rayonne-ments imposées
par la FCC / IC pour un environ- nement non réglementé. L‘utilisation d‘autres ac-
cessoires non homologués par le fabricant remet en cause la conformité des normes
imposées par la FCC / IC. Cet équipement doit étre installé et utilisé à plus de 20 cm
entre le radiateur et votre corps.
Cet émetteur ne doit pas être positionné à proximité d‘une autre antenne ou d‘un
autre émetteur, ni utilisé avec une autre antenne ou un autre émetteur.
For NCC
使用此產品時應避免影響附近雷達系統之操作。
Taiwan
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻
率、加大功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立
即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線
電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之
干擾。
Việt nam
Kể từ ngày 1 tháng 12 năm 2012, các sản phẩm được sản xuất bởi Sennheiser tuân thủ
Thông tư 30/2011/TT-BCT quy định về giới hạn cho phép đối với một số chất độc hại
trong các sản phẩm điện và điện tử.
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com
Publ. 02/19, 582709/A01
582709_0219_A01_Compliance_Soundbar_MPa.indd 1 21.01.2019 11:30:01