SDW 5000 Series User Guide
Table Of Contents
- Package contents
- Product overview
- Connecting the base station
- Connecting the base station to the mains power supply
- Pairing and charging the headset before first use
- Connecting the base station to a fixed line phone – SDW 5 BS only
- Connecting the base station to a computer
- Connecting the base station to Bluetooth devices – BTD 800 USB only
- Reconnecting/disconnecting Bluetooth
- Connecting an optional USB headset or speakerphone
- Connecting an optional busy light
- Assembling and wearing the headset SDW 10 HS
- Adjusting and wearing the headset SDW 30 HS | SDW 60 HS
- Labeling the headset
- Configuring the headset system
- Setting up and using the headset
- Making calls using the headset system
- Preparing calls - initial settings
- Selecting audio source – fixed line phone/ computer/ mobile phone
- Making a call
- Accepting/rejecting a call
- Transferring calls to connected devices
- Ending a call
- Redialing
- Putting a single active call on hold
- Managing multiple calls - two calls from two audio sources
- Setting up conference call
- Using the dictation mode
- Listening to music using the headset
- Using the motion sensor
- Charging the headset and storing the headset system
- Sharing a workplace
- Cleaning and maintaining the headset system
- If a problem occurs ...
- Specifications
SDW 5000 series headset system
SETTING UP AND USING THE HEADSET33
Verifying battery life
1s
You can retrieve information on the remaining battery life
at any time except when you are on a call or listening to
music:
Press the hook button for 1 second.
The remaining battery life is announced.
It is also possible to verify the remaining headset battery
life at any time via the base station battery LEDs.
Information announced Remaining battery life
“More than eighty percent battery left”
> 80%
“More than sixty percent battery left”
> 60%
“More than forty percent battery left”
> 40%
“More than twenty percent battery left”
> 20%
“Less than twenty percent battery left”
< 20%
„Recharge headset“
less than 15 minutes talk time; automatic voice prompt
Recharge headset (see page 46).
If you leave the DECT or Bluetooth range
100 m
In office buildings, the range between DECT headset and
base station is up to 100 m. Further information on how to
adjust radio range is given on page 27).
The range between a Bluetooth headset and base station
or between the mobile phone and the base station/dongle
is device dependent.
If the audio quality deteriorates during a call or the link
breaks down completely, the voice prompt “device
disconnected” is announced in the headset. The LED on
the headset is off and the LED
on the base station lights
up red.
Re-enter the radio range of the base station to resume
the call.
If your softphone supports call control, the call will
automatically be ended 60 seconds after leaving the
radio range.