SDW 5000 Series User Guide
Table Of Contents
- Package contents
- Product overview
- Connecting the base station
- Connecting the base station to the mains power supply
- Pairing and charging the headset before first use
- Connecting the base station to a fixed line phone – SDW 5 BS only
- Connecting the base station to a computer
- Connecting the base station to Bluetooth devices – BTD 800 USB only
- Reconnecting/disconnecting Bluetooth
- Connecting an optional USB headset or speakerphone
- Connecting an optional busy light
- Assembling and wearing the headset SDW 10 HS
- Adjusting and wearing the headset SDW 30 HS | SDW 60 HS
- Labeling the headset
- Configuring the headset system
- Setting up and using the headset
- Making calls using the headset system
- Preparing calls - initial settings
- Selecting audio source – fixed line phone/ computer/ mobile phone
- Making a call
- Accepting/rejecting a call
- Transferring calls to connected devices
- Ending a call
- Redialing
- Putting a single active call on hold
- Managing multiple calls - two calls from two audio sources
- Setting up conference call
- Using the dictation mode
- Listening to music using the headset
- Using the motion sensor
- Charging the headset and storing the headset system
- Sharing a workplace
- Cleaning and maintaining the headset system
- If a problem occurs ...
- Specifications
SDW 5000 series headset system
MAKING CALLS USING THE HEADSET SYSTEM34
Making calls using the headset system
In the following chapters the most important functions of the connected devices will be explained. Some functions
depend on the configuration of the base station (see page 26).
For information on how to set up a teleconference combining multiple phone calls or headsets see chapter “Setting
up conference call” on page 40.
If the optional UI 10 BL is connected (see page 17) the current state will be indicated by the busy light (see page 8).
Preparing calls - initial settings
Call control – manage calls directly via the headset:
Visit our website at www.sennheiser.com and check whether your softphone is supported.
Install our free software to enable call control support – if required.
Ensure your BTD 800 USB dongle is paired and connected to your mobile phone (see page 14).
Selecting audio source – fixed line phone/ computer/ mobile phone
Touch the icon of the desired audio source on your base station / / .
The chosen audio source is in focus and the LED lights up white.
If for example
is in focus, press the hook button (or touch the icon again) to initiate a call via your fixed line
phone – depending on the settings. The fixed line phone will remain your default audio source for outgoing calls
until you change it.