SDW 5000 Series User Guide
Table Of Contents
- Package contents
- Product overview
- Connecting the base station
- Connecting the base station to the mains power supply
- Pairing and charging the headset before first use
- Connecting the base station to a fixed line phone – SDW 5 BS only
- Connecting the base station to a computer
- Connecting the base station to Bluetooth devices – BTD 800 USB only
- Reconnecting/disconnecting Bluetooth
- Connecting an optional USB headset or speakerphone
- Connecting an optional busy light
- Assembling and wearing the headset SDW 10 HS
- Adjusting and wearing the headset SDW 30 HS | SDW 60 HS
- Labeling the headset
- Configuring the headset system
- Setting up and using the headset
- Making calls using the headset system
- Preparing calls - initial settings
- Selecting audio source – fixed line phone/ computer/ mobile phone
- Making a call
- Accepting/rejecting a call
- Transferring calls to connected devices
- Ending a call
- Redialing
- Putting a single active call on hold
- Managing multiple calls - two calls from two audio sources
- Setting up conference call
- Using the dictation mode
- Listening to music using the headset
- Using the motion sensor
- Charging the headset and storing the headset system
- Sharing a workplace
- Cleaning and maintaining the headset system
- If a problem occurs ...
- Specifications
SDW 5000 series headset system
MAKING CALLS USING THE HEADSET SYSTEM41
Setting up a large conference with up to 4 SDW series headsets
The headset system allows you to make a conference call with up to 4 SDW 5000 headsets. The first paired headset
(MASTER) is used to control the call.
1
New MASTER
2x
2
New MASTER
If you want to use a new MASTER headset:
Place the headset into the base station.
The Headset LED alternately flashes blue/red until a
link to the base station is established. The Headset
LED flashes blue twice.
Put on the MASTER headset.
Change audio source – if required (see page 34).
3
2x
GUEST 1-3
4
MASTER
GUEST 1-3
Press and hold the Mute & Volume button while
placing the GUEST headset into the base station of the
MASTER headset.
The Headset LED alternately flashes blue/red until a
link to the base station is established. The Headset
LED flashes blue twice.
The voice prompt “Conference pairing“ is announced
in the MASTER headset.
Take the GUEST headset out of the base station.
To add the GUEST headset to the conference call,
press the hook button on the MASTER headset within
10 seconds.
The voice prompt “Conference pairing successful“ is
announced in the GUEST headset.
Add additional GUEST headsets – if required.