SDW 5000 Series User Guide
Table Of Contents
- Package contents
- Product overview
- Connecting the base station
- Connecting the base station to the mains power supply
- Pairing and charging the headset before first use
- Connecting the base station to a fixed line phone – SDW 5 BS only
- Connecting the base station to a computer
- Connecting the base station to Bluetooth devices – BTD 800 USB only
- Reconnecting/disconnecting Bluetooth
- Connecting an optional USB headset or speakerphone
- Connecting an optional busy light
- Assembling and wearing the headset SDW 10 HS
- Adjusting and wearing the headset SDW 30 HS | SDW 60 HS
- Labeling the headset
- Configuring the headset system
- Setting up and using the headset
- Making calls using the headset system
- Preparing calls - initial settings
- Selecting audio source – fixed line phone/ computer/ mobile phone
- Making a call
- Accepting/rejecting a call
- Transferring calls to connected devices
- Ending a call
- Redialing
- Putting a single active call on hold
- Managing multiple calls - two calls from two audio sources
- Setting up conference call
- Using the dictation mode
- Listening to music using the headset
- Using the motion sensor
- Charging the headset and storing the headset system
- Sharing a workplace
- Cleaning and maintaining the headset system
- If a problem occurs ...
- Specifications
SDW 5000 series headset system
SHARING A WORKPLACE48
Sharing a workplace
The SDW 5000 headsets and base stations are compatible with each other. If you share a workplace, you can use one
base station with different headsets.
TIM
Fredrik
TIM
Fredrik
2x
CH 30
Fredrik
Place the headset to be used into the magnetic holder
of the base station.
The Headset LED alternately flashes blue/red and
flashes blue twice if pairing is successful. The headset
is ready for use.
Charge the headsets that are not in use with the
optional headset charger CH 30 (see page 47).
Using the headset with a third party base station (DECT-GAP telephone)
5s
Place the headset at a maximum distance of 1 m from
the third party base station.
Press and hold the headset’s hook button and mute
button simultaneously until you hear 3 beeps, then
release the button.
The headset switches to a special pairing mode and
the Headset LED flashes blue/red alternately.
Set the third party base station to a special pairing
mode (see the instruction manual of the third party
base station). The default code for the headset is
“0000”.
The headset pairs with the third party base station. If
pairing is successful, the Headset LED switches off.
If pairing is not successful within 60 seconds, the headset switches back to standby mode.
To pair the headset to a SDW 5000 series base station, after having paired it to a GAP enabled device:
Place the headset into the magnetic holder of the base station.
In this case, the pairing will not be initiated the first time, therefore:
Undock the headset and re-dock it again.
The headset LED flashes blue/red shortly and turns blue when pairing is complete. The headset will start charging.