Operation Manual
Table Of Contents
- Safety instructions
- Delivery includes
- Product overview
- Putting the Set 900 into operation
- Using the Set 900
- Switching the transmitter on/off
- Switching the receiver on/off
- Searching for a sound source
- Adjusting the volume
- Adjusting the balance
- Switching between mono and stereo operation
- Individually enhancing the speech intelligibility
- Switching the microphones on/off
- Storing and charging the receiver
- Charging a rechargeable battery in the transmitter’s charging compartment
- Folding up the receiver for transportation
- What if...
- Cleaning the Set 900
- If a problem occurs ...
- Additional technical information
- Accessories and spare parts
- Specifications
- Manufacturer declarations
- Index
13
Using the Set 900
왘 If you still haven’t found your sound source, press the
channel search button
7 once more.
Notes:
– The channel indicator goes off after 30 seconds so
that the light won’t disturb you in a dark room.
– When using the receiver without the transmitter on
the move (e.g. in a theater), please note that different
information can be transmitted on the channels. Ask
an employee of the venue which information is trans-
mitted on which channel.
왘 Put the receiver on.
The channel indicator on the
receiver lights up:
For an overview of the channel indi-
cator indications, see table below.
Do you hear the desired sound
source?
Yes:
The receiver has already found the
sound source.
No:
왘 Briefly press the channel search
button 7.
The sound source is searched for. On
the receiver, the channel indicator
can light up as follows:
Channel
indicator
Frequency You hear
the sound in
2.3+2.8 MHz stereo
2.3 MHz
mono
2.8 MHz
95 kHz
1
7
1