Instruction manual SK 2000
Table Of Contents
- SK_2000_U1_U4_549128_1013_INT_EN
- SK2000_529677_0409_PRT_US
- Important safety instructions
- The SK 2000 bodypack transmitter
- Delivery includes
- Product overview
- Putting the bodypack transmitter into operation
- Using the bodypack transmitter
- Using the operating menu
- Synchronizing the bodypack transmitter with a receiver
- Cleaning the bodypack transmitter
- If a problem occurs ...
- Specifications
22
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
RF signal available,
no audio signal,
“MUTE” appears on
the display panel
Bodypack trans-
mitter is muted
(MUTE)
Cancel the muting
(see page 13).
Receiver’s squelch
threshold is
adjusted too high
Reduce the squelch
threshold setting on
the receiver.
Bodypack trans-
mitter doesn’t
transmit a pilot
tone
Activate or deactivate the
pilot tone transmission
(“Pilot Tone” menu item).
Audio signal has a
high level of back-
ground noise or is
distorted
Bodypack trans-
mitter’s sensitivity
is adjusted too
low/too high
Adjust the input
sensitivity (“Sensitivity”
men
u item).
Problem Possible cause Possible solution