Instruction manual SKM 100 G3
Table Of Contents
- Important safety instructions
- The SKM 100 G3 radio microphone family
- Delivery includes
- Product overview
- Putting the radio microphone into operation
- Using the radio microphone
- Using the operating menu
- Adjusting settings via the operating menu
- The main menu “Menu”
- The extended menu “Advanced Menu”
- Setting transmission frequencies and the frequency bank “U” – “Tune”
- Setting a transmission frequency for the current channel
- Selecting a channel and assigning this channel a frequency
- Activating/deactivating the pilot tone transmission – “Pilot Tone”
- Adjusting the contrast of the display panel – “LCD Contrast”
- Loading the factory-preset default settings – “Reset”
- Displaying the software revision – “Software Revision”
- Adjustment tips
- Cleaning the radio microphone
- If a problem occurs ...
- Specifications
16
Adjusting settings via the operating menu
Adjusting settings via the operating
menu
The main menu “Menu”
Adjusting the input sensitivity – “Sensitivity”
Adjustment range: 0 to –48 dB, adjustable in steps of 6 dB
The transmitter’s audio level display “AF” always indicates the audio level,
even if the radio microphone is muted, e.g. allowing you to check the
adjusted sensitivity before live operation.
The following figures are a guide to the best settings:
Selecting the frequency bank and the channel manually –
“Frequency Preset”
When you are in the “Frequency Preset” menu item, the RF signal is
deactivated.
Make use of the possibility to adjust settings via the operating
menu of your receiver and to transfer these settings to the radio
microphone. For more information, refer to the instruction
manual of the receiver. The relevant information is marked with
the sync icon.
For more detailed information on the operating menu, visit the
SKM 100 G3 product page at www.sennheiser.com.
Input sensitivity
adjusted ...
Effect/display
... too high Close talking distances, speakers with loud voices
or loud music passages cause overmodulation in
the transmission link.
The audio level display “AF” 햲 shows full deflec-
tion for
the duration of the overmodulation.
... correctly The audio level display “AF” 햲 shows full
deflection only during the loudest passages.
... too low The transmission link is undermodulated. This
results in a signal with high background noise.
Transmission situation Sensitivity setting
Loud music/vocals −48 to −18 dB
Presentations −18 to −12 dB
Interviews −12 to 0 dB
Menu
–12 dB
Sensitivity
–12 dB
Sensitivity
–36 dB
Sensitivity
“Stored”
Call up
“Sensitivity”
Select the desired
setting
Store the setting
MHz
533.875
B.Ch: 20.12
MUTE
P
AF
햲
Menu
B.Ch:
1. 1
B.Ch:
MHz
Frequency Preset
Frequency Preset
1. 1
B.Ch:
MHz
Frequency
20. 1
516.200
533.875
Call up “Frequency
Preset”
Select the frequency
bank and confirm
Select the channel;
store the setting
“Stored”