Instruction manual SKM 100 G3
Table Of Contents
- Important safety instructions
- The SKM 100 G3 radio microphone family
- Delivery includes
- Product overview
- Putting the radio microphone into operation
- Using the radio microphone
- Using the operating menu
- Adjusting settings via the operating menu
- The main menu “Menu”
- The extended menu “Advanced Menu”
- Setting transmission frequencies and the frequency bank “U” – “Tune”
- Setting a transmission frequency for the current channel
- Selecting a channel and assigning this channel a frequency
- Activating/deactivating the pilot tone transmission – “Pilot Tone”
- Adjusting the contrast of the display panel – “LCD Contrast”
- Loading the factory-preset default settings – “Reset”
- Displaying the software revision – “Software Revision”
- Adjustment tips
- Cleaning the radio microphone
- If a problem occurs ...
- Specifications
21
Cleaning the radio microphone
Cleaning the radio microphone
Use a slightly damp cloth to clean the radio microphone from time to
time. Do not use any solvents or cleansing agents.
To clean the sound inlet basket:
Unscrew the upper sound inlet basket from the microphone head by
turning it counterclockwise (see diagram).
Remove the foam insert.
To clean the sound inlet basket:
– Use a slightly damp cloth to clean the upper sound inlet basket from
the inside and outside.
OR
– Scrub with a brush and rinse with clear water.
If necessary, clean the foam insert with a mild detergent or replace the
foam insert.
Dry the upper sound inlet basket.
Dry the foam insert.
Reinsert the foam insert.
Replace the sound inlet basket on the microphone head and screw it
tight.
You should also clean the contact rings of the microphone head from time
to time:
Wipe the contact rings of the microphone head with a dry cloth.
CAUTION! Liquids can damage the electronics of the radio micro-
phone!
Liquids entering the housing of the device can cause a
short-circuit and damage the electronics.
Keep all liquids away from the radio microphone.
CAUTION! Liquids will damage the microphone module!
Liquids will damage the microphone module.
Only clean the upper sound inlet basket.