Instruction manual SKM 100 G3
Table Of Contents
- Important safety instructions
- The SKM 100 G3 radio microphone family
- Delivery includes
- Product overview
- Putting the radio microphone into operation
- Using the radio microphone
- Using the operating menu
- Adjusting settings via the operating menu
- The main menu “Menu”
- The extended menu “Advanced Menu”
- Setting transmission frequencies and the frequency bank “U” – “Tune”
- Setting a transmission frequency for the current channel
- Selecting a channel and assigning this channel a frequency
- Activating/deactivating the pilot tone transmission – “Pilot Tone”
- Adjusting the contrast of the display panel – “LCD Contrast”
- Loading the factory-preset default settings – “Reset”
- Displaying the software revision – “Software Revision”
- Adjustment tips
- Cleaning the radio microphone
- If a problem occurs ...
- Specifications
22
If a problem occurs ...
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at www.sennheiser.com
under “Service & Support”.
Problem Possible cause Possible solution
Radio micro-
phone cannot
be operated,
“Locked”
appe
ars on the
display panel
Lock mode is activated Deactivate the lock mode
(siehe Seite 12).
No operation
indication
Batteries are flat or
accupack is flat
Replace the batteries or
recharge the accupack
(siehe Seite 9).
No RF signal at
the receiver
Radio microphone and
receiver are not on the
same channel
Synchronize the radio
microphone with the
receiver.
Set the radio microphone
to the same channel as the
receiver.
Radio microphone is out
of range
Check the squelch
threshold setting on
the receiver.
Reduce the distance
between radio micro-
phone and receiving
antenna.
RF signal is deactivated
(“RF Mute“)
Activate the RF signal
(siehe Seite 12).
RF signal
available,
no audio signal,
“MUTE”
appe
ars on the
display panel
Receiver’s squelch
threshold is adjusted too
high
Reduce the squelch
threshold setting on the
receiver.
Radio microphone
doesn’t transmit a pilot
tone
Activate or deactivate the
pilot tone transmission
(siehe Seite 19).
Audio signal
has a high level
of background
noise / audio
signal is
distorted
Radio microphone’s
sensitivity is adjusted too
low/too high
Adjust the input sensi-
tivity (siehe Seite 16).