Instruction manual
20
Adjusting settings via the operating menu
Setting the mode for the MIC button – “Mute Mode”
For information on the use of the MIC button, refer to page 12.
Adjusting the transmission power – “RF Power”
Via the “RF Power” menu item, you can adjust the transmission power in
two steps. It is vital to observe the notes on the supplied frequency
information sheet!
Activating/deactivating the pilot tone transmission –
“Pilot Tone”
The radio microphone adds an inaudible pilot tone to the audio signal. The
receiver detects and evaluates the pilot tone, and is thus able to identify
the signal of the matching transmitter and mute all others. The pilot tone
supports the receiver’s squelch function.
Devices of the ew 300 G1 series (generation 1) do not support the pilot
tone function. Therefore, please observe the following when combining a
radio microphone or receiver of the ew 300 G3 series (generation 3) with
devices from an earlier evolution wireless generation:
Mode Function
“AF On/Off” If you press the MIC button, the audio signal is muted.
“RF On/Off” If you press the MIC button, t
he radio signal is
deactivated
.
“Push To Mute” The audio signal is muted as long as you press the
MIC button.
“Push To Talk”
*
* If you select “Push To Talk”, the radio microphone will be muted until
the MIC button is pressed
.
The audio signal is activated as long as you press the
MIC button.
“Disabled” The function is deactivated.
Radio microphone Receiver Make sure to ...
w G3/ w G2 w G3/ w G2
... activate the pilot tone func-
tion on both radio microphone
and receiver.
w G3 w G1
... deactivate the pilot tone
function on the ew 300 G3
radio microphone.
w G1 w G3
... deactivate the pilot tone
function on the ew 300 G3
receiver.
Call up
“Mute Mode”
Select the desired
setting
Store the setting
Advanced
Menu
Mute Mode
Mute Mode
Mute Mode
RF On/OffAF On/Off
“Stored”
AF On/Off
Call up
“RF Power”
Select the desired
setting
Store the setting
Advanced
Menu
RF Power
Standard
Standard
RF Power
Low
RF Power
“Stored”
Call up
“Pilot Tone”
Select the desired
setting
Store the setting
Name
Advanced
Menu
Pilot Tone
Active
Active
Pilot
Inactive
Pilot
“Stored”