Instruction Manual SKM 500 G3

26
Synchronizing the radio microphone with a receiver
Synchronizing the radio
microphone with a receiver
When synchronizing the radio microphone with a receiver,
please observe the following:
Synchronizing the radio microphone with
the receiver – individual operation
Upon delivery, the radio microphone and the receiver are
synchronized with each other.
If, however, you cannot establish a transmission link
between radio microphone and receiver, you have to
synchronize the channels of the devices.
For information on automatic synchronization of the radio
microphone with the receiver (individual operation), refer
to the instruction manual of the receiver. This information
is marked with the icon.
Alternatively, you can set the channel on the radio micro-
phone manually:
 Make sure that you set the radio microphone to the
same frequency bank and the same channel as the
receiver (see page 21).
If you still cannot establish a transmission link, refer to the
chapter “If a problem occurs ...” on page 29.
Synchronizing radio microphones with
receivers – multi-channel operation
Combined with ew 500 G3 receivers, ew 500 G3 radio
microphones can form transmission links that can be used
in multi-channel systems.
For information on automatic synchronization of radio
microphones with receivers (multi-channel operation),
refer to the instruction manual of your receiver.
For more information on multi-channel operation, visit the
SKM 500 G3 product page at www.sennheiser.com.
 Only use a transmitter and a receiver from the
same frequency range (see the type plate on the
transmitter and the receiver).
 Make sure that the desired frequencies are listed
in the enclosed frequency information sheet.
 Make sure that the desired frequencies are
approved and legal in your country and, if neces-
sary, apply for an operating license.