Instruction Manual SKM 500 G3
Table Of Contents
- Important safety instructions
- The SKM 500 G3 radio microphone family
- Delivery includes
- Product overview
- Putting the radio microphone into operation
- Using the radio microphone
- Using the operating menu
- Adjusting settings via the operating menu
- Synchronizing the radio microphone with a receiver
- Cleaning the radio microphone
- Recommendations and tips
- If a problem occurs ...
- Accessories and spare parts
- Specifications
- Index
28
Recommendations and tips
Recommendations and tips
... for optimum sound
• Hold the radio microphone in the middle of the micro-
phone body. Holding it close to the sound inlet basket
will influence the radio microphone’s pick-up pattern.
• You can vary the bass reproduction by increasing/
decreasing the talking distance.
• For best results, make sure that the sensitivity is
correctly adjusted.
... for optimum reception
• Transmission range depends to a large extent on loca-
tion and can vary from about 10 m to about 150 m.
There should be a “free line of sight” between trans-
mitting and receiving antennas.
• To avoid overloading the receiver, observe a minimum
distance of 5 m between transmitting and receiving
antennas.
• Only hold the radio microphone by its body. If you
touch the antenna of the radio microphone, the trans-
mission range will be considerably reduced.
... for multi-channel operation
• For multi-channel operation, you should only use the
channels within one frequency bank. Each of the
frequency banks “1” to “20” accommodates factory-
preset frequencies which are intermodulation-free.
• When using several transmitters simultaneously,
interference can be avoided by maintaining a
minimum distance of 20 cm between two transmitters.