Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Recommendations on antenna mounting
41
tings (SL Rack Receiver DW: System Settings menu -> RF
Power) for the respective cable lengths:
• Cable length of 5 m -> at least level 1
• Cable length of 10 m -> selected level +1, at least level 2
• Cable length of 20 m -> selected level +1, at least level 3
• Cable length of 25 m and longer -> selected level +2, at least
level 4
Remote antenna distances and line of sight
If you are using multiple antenna wall mounts (AWM 2/AWM
4) in one room or if individual installation and mounting of the
antennas is desired, please observe the following aspects:
▷ Position all antennas as close as possible to each other.
▷ Make sure that the distances between all antennas are all
equal and the same as on the back of the receiver or on the
AWM 2 antenna wall mount.
▷ If possible, group the antennae as follows:
• All A antennae from the receivers’ ANT I sockets in one
group according to the aforementioned requirements
• All B antennae from the receivers’ ANT II sockets in one
group according to the aforementioned requirements
►
Ant II Ant I
B
B
B
B
B
B
A
A
A
A
A
A
BBB
BBB
AAA
AAA
All antennas B from Ant II sockets
of all SL Rack Receiver DW units
All antennas A from Ant I sockets
of all SL Rack Receiver DW units
min. 17 cm (7")
minimum 7.5 cm (3")
recommended 17 cm (7")
≤ 1 m (39")
Distance to reflecting surface / obstacle:
min. 7.5 cm (3"), recommended 17 cm (7")
≤ 1 m (39")