Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Multi-room mode
52
Single-room setup with SL Rack Receiver DW only
▷ Install all receivers in one rack (see „Installing receivers in
a rack“).
▷ Connect all cables for the receivers (see „Connecting the
receiver“).
▷ Mount all antennas as recommended and feasible (see
„Recommendations on antenna mounting“).
▷ Ensure that all receivers are switched off.
▷ Switch on the first receiver. This receiver will become the
Master.
▷ If necessary, pair a transmitter. Only if necessary, as the
sets are delivered already paired.
▷ Wait until both the LED of the receiver and the LED of the
transmitter light up green.
▷ Perform a walk test to ensure the best reception coverage
(see „Performing a walk test (reception quality)“).
▷ Switch on all other receivers. They will synchronize with
the Master. Make sure to leave the Master receiver
switched on during this step.
Single-room setup with SL Multi-Channel Receiver
DW only
▷ Install the SL Multi-Channel Receiver DW on a wall or the
ceiling with the front side of the receiver facing into the
room (see „Mounting the receiver“).
▷ Connect a LAN cable supplying PoE to the Dante I / PoE /
Ctrl RJ-45 socket of the first SL Multi-Channel Receiver
DW (see „Connecting the receiver“).
This receiver will become the Master.
▷ Wait until the LEDs of the receiver light up red.
▷ Connect a LAN cable supplying PoE to the respective Dan-