Instruction manual SpeechLine Digital Wireless

SL MCR DW
107
Putting the receiver into operation
Observe the following information during startup.
Connecting/disconnecting the receiver to/from the
power supply system
The receiver is powered using Power over Ethernet. As soon
as the power supply is established, the receiver switches on
automatically. There is no separate on/off switch.
▷ See „Connecting to the network (power supply and config-
uration)“.
When the receiver starts, all four LEDs light up green for about
20 seconds. Then the LEDs change to displaying the status of
the respective channel.
▷ See „Meaning of the status LEDs“.
Operating and configuring the receiver
The receiver is operated and configured using the Sennheiser
Control Cockpit control software. You cannot operate the re-
ceiver on the device itself.
▷ See „Controlling and monitoring the receiver via the net-
work“.
Controlling and monitoring the receiver via
the network
To configure and use the receiver, you need the free Sennhe-
iser Control Cockpit control software. You can download it
here:
www.sennheiser.com/control-cockpit-software
To use the Sennheiser Control Cockpit, you must
complete a one-time registration with your e-mail ad-
dress to receive the software activation code.