Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Pairing
161
If no radio link was successfully established, Pairing
failed appears on the display panel of both the receiver
and the transmitter (only for SL Handheld DW and SL
Bodypack DW) and the status LEDs on the transmitter and the
receiver light up red.
If you try to pair devices that are running incompatible
firmware versions, a message appears on the display
panel prompting you to update the firmware of the
transmitter.
If you update the firmware now, the transmitter and the re-
ceiver will be paired afterwards.
If you do not update the firmware, the transmitter and the re-
ceiver will not be paired and FW mismatch appears on the
display panel of the receiver.
We recommend updating the receiver firmware first and then
the transmitter firmware.
▷ When updating the firmware, make sure that only the
transmitter whose firmware is currently being updated is
switched on. All other transmitters should be switched off.