Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
The SL PASC 4 passive antenna splitter/combiner
212
Fastening the mounting angles (to install an anten-
na splitter)
To fasten the mounting angles:
▷ Remove the two recessed head screws on each side of the
antenna splitter.
▷ Fasten the mounting angles to the sides of the antenna
splitter by tightening the previously removed recessed
head screws.
Make sure that the angled ends of the mounting angles
point forward.
►
Installing the antenna splitter in a rack
To install the antenna splitter in a rack:
▷ Screw the front panel from the GA 4 mounting kit onto the
antenna splitter’s mounting angle using the two included
recessed head screws as shown in the figure.
Make sure to use the correct side (the one with the round
holes) of the blanking plate to secure it to the mounting an-
gle.
►
▷ Insert the two small blanking plugs into the unused antenna