Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
The SL PASC 4 passive antenna splitter/combiner
213
holes.
▷ Screw the unit consisting of antenna splitter and mounting
accessories into a 19" rack.
Mounting the jointing plate and fastening the
mounting angles (to install two antenna splitters
side by side)
To fasten the mounting angles:
▷ Remove the two recessed head screws on both outer-fac-
ing sides of the antenna splitters.
▷ Fasten the mounting angles to the outer-facing sides of the
antenna splitters using the previously removed recessed
head screws.
To mount the jointing plate:
▷ Place the two antenna splitters side by side on a flat sur-
face with the undersides facing upward.
▷ Screw the two antenna splitters together using the jointing
plate and the six recessed head screws, as shown in the
figure.
►
▷ Screw the unit consisting of the two antenna splitters into
a 19" rack.