Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
SL MCR DW
107
Putting the receiver into operation
Observe the following information during startup.
Connecting/disconnecting the receiver to/from the
power supply system
The receiver is powered using Power over Ethernet. As soon
as the power supply is established, the receiver switches on
automatically. There is no separate on/off switch.
▷ See „Connecting to the network (power supply and config-
uration)“.
When the receiver starts, all four LEDs light up green for about
20 seconds. Then the LEDs change to displaying the status of
the respective channel.
▷ See „Meaning of the status LEDs“.
Operating and configuring the receiver
The receiver is operated and configured using the Sennheiser
Control Cockpit control software. You cannot operate the re-
ceiver on the device itself.
▷ See „Controlling and monitoring the receiver via the net-
work“.
Controlling and monitoring the receiver via
the network
To configure and use the receiver, you need the free Sennhe-
iser Control Cockpit control software. You can download it
here:
www.sennheiser.com/control-cockpit-software
To use the Sennheiser Control Cockpit, you must
complete a one-time registration with your e-mail ad-
dress to receive the software activation code.