Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Performing a walk test (reception quality)
167
Good reception quality is indicated by a tick.
If the tick is missing, reception quality is sufficient.
If reception quality is or was compromised at any posi-
tion, this is indicated by a warning triangle.
The warning triangle remains displayed on the display panel
even if reception quality improves afterwards.
NO LINK: If the radio link breaks down completely, the back-
ground of the display panel changes back and forth between
light and dark and No Link appears on the display panel.
▷ Press the ESC button on the receiver to end the walk test.
If the result of the walk test is not satisfying, you can take the
following remedial measures:
• If possible, reposition the receivers so that there is always a
direct line of sight between the receiver antennas and the
paired transmitter.
• If possible, remove obstacles between the transmitter and
the receiving antennae.
• When rack mounting receivers, you should mount their rod
antennae to the front of the rack using the GA 4 rack-mount
kit.
• If you have manually adjusted the transmission power, you
may have to readjust it via the receiver's operating menu:
System Settings -> RF Power. You can find more informa-
tion under „Multi-room mode“.