Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
The CHG 4N charger
189
Controlling and monitoring the CHG 4N char-
ger over the network
You can connect the CHG 4N charger to a network using a
router or switch, which allows you to monitor and control the
accupack’s charge level using the Sennheiser Control Cock-
pit software and to modify the CHG 4N charger’s network con-
figuration.
For more information on controlling a system in the network
using the Sennheiser Control Cockpit software, refer to the
instruction manual of the software.
Please note that the host PC on which the Sennheiser Control
Cockpit Service is installed must be in the same network as
the devices that are to be monitored and controlled.
Connecting the CHG 4N charger to the network
To connect the charger using the Sennheiser Control Cockpit
app:
▷ Connect a standard network cable (at least Cat 5) to the
Ethernet socket of the charger.
▷ Connect the other end of the network cable to the network,
e.g. to a switch or router, or directly to a PC to make initial
configuration easier.
The yellow LED next to the CHG 4N charger’s Ethernet socket
indicates the connection status:
Yellow LED:
• On -> The charger is connected to the network
• Off -> The charger is not connected to the network
►