Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Recommendations on antenna mounting
44
Combining up to 4 links using the AWM 2 and the
SL PASC 4
The following illustration shows an example of how to com-
bine up to 4 links with one AWM 2 antenna wall mount. This re-
duces the number of antenna cables required from 8 to 2.
►
▷ Please observe the information below on the length of the
extension cables („Signal loss due to extension cables and
antenna splitters“).
Always combine all antenna sockets ANT I of all receiv-
ers and all antenna sockets ANT II of all receivers re-
spectively to one of the two antennas of the AWM 2. If
you are using only 3 of the 4 connections on the antenna split-
ter, you should close the unused connection with a terminat-
ing resistor (50 Ω) to minimize interfering signals and
maximize transmission power.
SL RACK RECEIVER DW ANTENNA I
SL RACK RECEIVER DW ANTENNA II
ANT I
ANT II
1234
1234
SL Rack Receiver DW
SL PASC 4
AWM 2
Cables for connecting the SL PASC 4 to
the SL Rack Receiver DW are supplied
with the SL PASC 4.
Use the following Sennheiser cables
for connecting the AWM 2 to the SL
PASC 4:
CL 5 (5 m / 16.4 ft)
art. no. 505976
CL 10 (10 m / 32.8 ft)
art. no. 506263