Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
SL Rack Receiver DW
81
Mounting the jointing plate and fastening the
mounting angles (to install two receivers side by
side)
To fasten the mounting angles:
▷ Unscrew and remove the two recessed head screws on the
outward-facing sides of the receiver.
▷ Secure the mounting angles to the outward-facing sides of
the receiver using the previously removed recessed head
screws.
To mount the jointing plate:
▷ Place the two receivers side by side upside-down onto a
flat surface.
▷ Secure the jointing plate to the receiver using the six re-
cessed head screws as shown.
►
Connecting the AWM 2 / AWM 4 remote antenna to
the receiver
Instead of the supplied rod antennae, you can also connect a
remote antenna to the receiver. For more information, see
„The AWM 2 antenna wall mount“ and „The AWM 4 antenna
wall mount“.
▷ Pay attention to the notes about antenna installation under
„Recommendations on antenna mounting“.