Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
SL MCR DW
96
Connecting the receiver
The receiver can output analog and digital audio signals.
The analog audio signal is output via the 3-pin Analog Out ter-
minal.
Digital audio signals are output via the Dante interface with
two RJ-45 sockets. This interface is also used for control and
configuration via the network and for Power over Ethernet
supply.
The following variants are possible:
►
To configure the variants you need the Audinate Dan-
te Controller software: www.audinate.com
PoE /
network control
digital audio
PoE /
network control
digital audio digital audio
PoE /
network control
digital audio
Variant 1
Single Cable Mode (default)
Variant 2
Audio Redundancy Mode
Variant 3
Split Mode
daisy chain