Planning and setting up single-room and multi-room installations with SpeechLine Digital Wireless

AN 1106 v2.0 | 7/12
System planning for single-room and multi-room installations
SpeechLine Digital Wireless
Single-room setup with SL Multi-Channel Receiver DW only
For an installation in one single room using only the SL Multi-Channel Receiver DW please observe
the following steps:
f Install the SL Multi-Channel Receiver DW to a wall or the ceiling with the front side of the recei-
ver facing into the room.
f Connect a LAN cable supplying PoE to the Dante I / PoE / Ctrl RJ-45 socket of the
SL Multi-Channel Receiver DW.
This receiver will become the Master.
f Wait until the LEDs of the receiver light up red.
f Connect a LAN cable supplying PoE to the respective Dante I / PoE / Ctrl RJ-45 sockets of all
other SL Multi-Channel Receiver DW units.
They will synchronize with the Master.
When you are using multiple SL Multi-Channel Receiver DW units, it is possible to dai-
sy-chain the network and audio signals by using the “Single-Cable Mode” (factory default
setting).
PoE will not be daisy-chained, so a PoE injector is required for any additional
SL Multi-Channel Receiver DW.
Single-room setup with both SL Rack Receiver DW and
SL Multi-Channel Receiver DW
For an installation in one single room using both the SL Rack Receiver DW and the SL Multi-Channel
Receiver DW please observe the following steps:
f Install the SL Multi-Channel Receiver DW to a wall or the ceiling with the front side of the recei-
ver facing into the room.
f Install all SL Rack Receiver DW units in one rack and connect all cables (power, audio and LAN).
f Mount all antennas for the rack receivers as recommended and feasible.
f Connect a LAN cable supplying PoE to the Dante I / PoE / Ctrl RJ-45 socket of the first
SL Multi-Channel Receiver DW.
This receiver will become the Master.
f Wait until the LEDs of the receiver light up red.
f Connect a LAN cable supplying PoE to the respective Dante I / PoE / Ctrl RJ-45 sockets of all
other SL Multi-Channel Receiver DW units.
They will synchronize with the Master.
f Switch on all rack receivers.
They will synchronize with the Master.
When you are using multiple SL Multi-Channel Receiver DW units, it is possible to dai-
sy-chain the network and audio signals by using the “Single-Cable Mode” (factory default
setting).
PoE will not be daisy-chained, so a PoE injector is required for any additional
SL Multi-Channel Receiver DW.