Instruction manual SpeechLine Digital Wireless

Performing a walk test (reception quality)
165
The display of the radio signal level is continuously updat-
ed.
▷ Click Stop to end the walk test.
If the result of the walk test is not satisfying, you can take the
following remedial measures:
• If possible, position the receiver so that there is always a di-
rect line of sight between the receiver and the paired trans-
mitter.
• If possible, remove obstacles between the transmitter and
the receiver.
• If necessary, adjust the manually selected transmission
power in the Control Cockpit under RF power mode on the
RF settings tab. You can find more information under
„Multi-room mode“.
Performing a walk test with the
SL Rack Receiver DW in the Control Cockpit
To perform a walk test in the Control Cockpit:
▷ Switch on the transmitter and the receiver of the radio link
you want to check.
▷ In addition, switch on all other devices that you want to use
in the operating environment.
▷ Select the device in the Control Cockpit.
▷ Open the RF settings tab.
►
▷ Click Start under Walk Test.
►
▷ Walk the operating environment with the transmitter.
The display of the radio signal level is continuously updat-