Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Planning
37
Analysis of the environmental conditions
When planning the installation of a SpeechLine Digital Wire-
less system, you should also carefully analyze the environ-
mental conditions. Are there any other 1.9 GHz devices (e.g.
DECT telephones or DECT access points) already installed?
Observe the following aspects when planning an in-
stallation
▷ Identify the locations of DECT access points (e.g. for DECT
telephone systems). Also observe the information provided
under „Shared use of the 1.9 GHZ frequency band“.
▷ Determine the type of installation, i.e. where and how the
microphone receivers are to be installed.
▷ Determine whether the antennae are to be mounted re-
motely from the receivers. When remote mounting the an-
tennae, also take into account possible losses due to long
cable runs. Also see „Recommendations on antenna
mounting“.
▷ When installing remote antennae, observe a minimum dis-
tance of 3 m to the next DECT access point.
▷ To make network control very simple, we recommend using
a network switch to connect the receivers in the network.