Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Recommendations on antenna mounting
45
Combining up to 8 links using the AWM 4 and two
SL PASC 4 units
The following illustration shows an example of how to com-
bine up to 8 links with one AWM 4 antenna wall mount. This re-
duces the number of antenna cables required from 16 to 4.
►
▷ Please observe the information below on the length of the
extension cables („Signal loss due to extension cables and
antenna splitters“).
Always combine all antenna sockets ANT I of up to four
receivers and all antenna sockets ANT II of up to four re-
ceivers respectively to the two sockets of one link of the
AWM 4. If you are not using all connections on the antenna
splitter, you should close the unused connections with a ter-
SL RACK RECEIVER DW ANTENNA I
SL RACK RECEIVER DW ANTENNA II
ANT I
ANT II
1234
1234
SL Rack Receiver DW
SL PASC 4
Link IILink I
AWM 4
SL RACK RECEIVER DW ANTENNA I
SL RACK RECEIVER DW ANTENNA II
ANT I
ANT II
1234
1234
SL Rack Receiver DW
SL PASC 4
Cables for connecting the SL PASC 4 to the SL Rack Receiver DW are supplied with the SL PASC 4.
Use the following Sennheiser cables for
connecting the AWM 4 to the SL PASC 4:
CL 1 PP (1 m / 3.3 ft)
art. no. 507425
CL 5 PP (5 m / 16.4 ft)
art. no. 507426
CL 10 PP (10 m / 32.8 ft)
art. no. 507427