Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Performing a walk test (reception quality)
165
The display of the radio signal level is continuously updat-
ed.
▷ Click Stop to end the walk test.
If the result of the walk test is not satisfying, you can take the
following remedial measures:
• If possible, position the receiver so that there is always a di-
rect line of sight between the receiver and the paired trans-
mitter.
• If possible, remove obstacles between the transmitter and
the receiver.
• If necessary, adjust the manually selected transmission
power in the Control Cockpit under RF power mode on the
RF settings tab. You can find more information under
„Multi-room mode“.
Performing a walk test with the
SL Rack Receiver DW in the Control Cockpit
To perform a walk test in the Control Cockpit:
▷ Switch on the transmitter and the receiver of the radio link
you want to check.
▷ In addition, switch on all other devices that you want to use
in the operating environment.
▷ Select the device in the Control Cockpit.
▷ Open the RF settings tab.
►
▷ Click Start under Walk Test.
►
▷ Walk the operating environment with the transmitter.
The display of the radio signal level is continuously updat-