Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
The AWM 2 antenna wall mount
201
▷ Smaller bend radiuses can cause cracks and breaks in the
cable, which may not be visible from the outside. This can
result in bad reception quality.
▷ Screw the sockets to the antenna holes using the supplied
washers and nuts.
▷ Screw the cover back to the antenna housing. Observe cor-
rect cable routing.
▷ Connect the two rod antennae of the antenna wall mount to
the R-SMA sockets.
▷ Use the elongated mounting holes to mount the antenna
wall mount to a wall or screw the antenna wall mount onto
a microphone stand with a 3/8" thread.
The antenna cables can be run from the rear panel of the
antenna housing directly trough a wall. When wall mount-
ing the antenna wall mount, observe a minimum distance of
160 mm between the top of the antenna wall mount and the
ceiling.
▷ If necessary, connect extension cables to the R-SMA sock-
ets of the antenna wall mount.
▷ Connect the R-SMA connectors to the R-SMA sockets of
the receiver.
You can find additional information on possible set-
ups using the AWM 2 and general recommendations
on antenna usage under „Recommendations on an-
tenna mounting“.