Instruction manual SpeechLine Digital Wireless
Table Of Contents
- SpeechLine Digital Wireless: System Information
- Focus on the spoken word
- The Products of the SpeechLine Digital Wireless Series
- Accessories
- SpeechLine Digital Wireless: System planning
- Planning
- Recommendations on antenna mounting
- Antenna setup and planning for SpeechLine Digital Wireless
- Antenna mounting options
- Option 1: Connecting the AWM 2 or AWM 4 antenna wall mount directly to the receiver(s)
- Option 2: Combining multiple links to one AWM 2/AWM 4
- Option 3: Rack mounting - front
- Option 4: Rack mounting - rear
- Further important information on antenna usage
- Multi-room mode
- SpeechLine Digital Wireless: Instruction manual
- SL Rack Receiver DW
- Product overview and operating elements – front panel
- Product overview and connections – rear panel
- Connecting the receiver
- Controlling and monitoring the receiver via the network
- Updating the firmware
- Setting up the receiver
- Installing receivers in a rack
- Displays on the receiver’s display panel
- Using the operating menu of the receiver
- SL MCR DW
- The SL Handheld DW
- The SL Bodypack DW
- The SL Tablestand 133-S DW
- The SL Tablestand 153-S DW
- The SL Boundary 114-S DW
- Pairing
- Performing a walk test (reception quality)
- The SL Headmic 1 headset microphone
- The MKE 1 clip-on microphone
- The CHG 2 charger
- The CHG 4N charger
- The CHG 2W charging base
- The AWM 2 antenna wall mount
- The AWM 4 antenna wall mount
- The SL PASC 2 passive antenna splitter/ combiner
- The SL PASC 4 passive antenna splitter/ combiner
Multi-room mode
55
▷ Perform a walk test to ensure the best reception coverage
(see „Performing a walk test (reception quality)“).
▷ If necessary adjust the RF power level and repeat the walk-
test for verification.
▷ Make sure to leave the Master receiver switched on for all
following steps.
▷ Then, switch on all other receivers. They will synchronize
with the Master.
▷ Set all other receivers to the same RF power level as the
Master receiver.
▷ Power cycle the other receivers. The Master receiver must
be switched on all the time.
▷ Once the rack is configured, all devices must be switched
off/on together every time via the central power switch of
the multiple socket.
▷ Make sure not to switch any receiver on or off individually.
Multi-Room Mode setup with SL Multi-Channel Re-
ceiver DW only
When installing SpeechLine Digital Wireless in several rooms,
it is crucial that you perform the following steps one after the
other and room by room. When installing SpeechLine Digital
Wireless devices in one room, all devices in all other rooms
must be switched off.
▷ Install all SL Multi-Channel Receiver DW units of one room
to a wall or the ceiling with the front sides of the receivers
facing into the room.
Note: to ensure the Master/Follower functionality the re-
ceivers should be installed side to side and not back to
back, as indicated in the following illustration.