transmitor User Manual

16
Connecting the transmitter to the mains
Both transmitters have no mains switch.
To connect the transmitter to the mains:
 Pass the cable through the cable grip .
 Connect the supplied mains cable to the 3-pin IEC mains socket .
 Plug the mains connector into the wall socket.
To disconnect the transmitter from the mains:
 Pull out the mains connector from the wall socket.
Connecting the amplifier/mixing console
 Connect the amplifier/mixing console to the XLR-3F sockets  (left and
MONO) or  (right).
Both balanced and unbalanced connection is possible (see “Connector
assignment” on page 39).
Note:
Any device that is only suitable for mono operation must be connected to
XLR-3F socket . In this case, set the transmitter to mono operation via
the menu.
 Via the “Sensitiv” menu, adjust the transmitter’s input sensitivity (see
“Adjusting the sensitivity (transmitter only)” on page 30).
Connecting the headphones/ monitoring the audio signal
To monitor the audio signal:
 Set the headphone volume control  to the lowest volume by turning it
to the left as far as possible.
 Connect headphones with a ¼” (6.3 mm) stereo jack plug to the
headphone output (PHONES) .
 Gradually turn up the volume.
CAUTION! Damage due to electric current!
If you connect the transmitter to an unsuitable power supply,
this can cause damage to the device.
 Use the supplied mains cable to connect the receiver to the
mains (100 to 240 V AC, 50 or 60 Hz).
 Ensure a reliable mains ground connection of the receiver –
especially when you are using multi-outlet power strips or
extension cables.
 

 
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
 Set the volume for the connected headphones to the
minimum before putting the headphones on.
Neue Abbildung
 
ew300_350_IEM_INT.book Seite 16 Freitag, 7. März 2008 8:55 08