ES1 Ceiling Audio Solution (TeamConnect Ceiling 2 and Bose)

Application Guide

ES-1 Audio System Set-up Guide for Microsoft Teams

April 2020 Page 3

Figure 4: Plan view showing the relative placement of TCC2 and EM180.

The ES1 base configuration, including one EM180 loudspeaker, is optimized for a 20-foot (6.1-

meter) conference room where the farthest listener is 14 feet (4.5 meters) away from the

loudspeaker. The TCC2 should be positioned to provide a line-of-sight path to each seat at

the table and should be no more than 11.5 feet (3.5 meters) from the farthest presenter.

Amplifier with AmpLink

P2600A is a two-channel versatile amplifier with 600 watts per channel and the ability to

assign high-Z and low-Z operation.

AmpLink is a proprietary near-zero-latency link between Bose processors and amplifiers and

can carry up to eight channels of digital audio on a single shielded Category 5 (STP) cable.

Connect the DSP and the AmpLink Input port on the amplifier as shown in (1) in Figure 5. The

transmit channel is assigned within the AmpLink output block of the signal processor. On the

amplifier-side, the appropriate receive channel is selected using the Input Select dial (2) set

to the appropriate transmit channel. Turn the dial to 2 to select the first two Amplink

channels. The odd-number channel is assigned to Output 1 and the even channel is assigned

to Output 2 (4). A 3-foot (1-meter) AmpLink cable is included with the amplifier.

Figure 5: Back panel view of the amplifier with important elements identified.

10ft ceiling