Operation Manual

ENFRITNLPTRUZH ES DE
Using the XS WIRELESS systems
XS WIRELESS | 9
Using the XS WIRELESS systems
Switching the receiver on/off
To switch the receiver on:
왘 Press the standby button
1. The receiver switches on, the display panel is backlit.
왘 Check the RF signal level “RF”
H on the receiver’s display panel.
– The RF signal level is not displayed: The receiver frequency is unused. You can put
your transmitter into operation.
– The RF signal level is displayed: The receiver frequency is already used. Read the
chapter “Selecting and changing a receiver channel”.
To switch the receiver to standby mode:
왘 Keep the standby button
1 pressed until “OFF” appears on the display panel.
To completely switch the receiver off:
왘 Disconnect the receiver from the mains by unplugging the mains unit from the wall
socket.
Switching the transmitters on/off
To switch the transmitters on:
왘 Press the ON/OFF button . The powerLED lights up red. The display panel of the
receiver and the transmitters displays the charge status of the batteries:
To switch the transmitters off:
왘 Keep the ON/OFF button pressed until “OFF” appears on the display panel.
Display on the receiver Display on the transmitter Charge status
approx. 100 %
approx. 70 %
approx. 30 %
The display and the power
LED are flashing.
The charge status is critical.
OFF
615.
375