Operation Manual

ENFRITNLPTRUZH ES DE
Using the XS WIRELESS systems
XS WIRELESS | 11
The menu items and their adjustment possibilities
TUNE menu item
왘 Use the UP button
3 or DOWN button 4 to select an unused frequency.
왘 Press the set button
6 to store your setting.
PRESET menu item
왘 Use the UP button
3 or DOWN button 4 to select a frequency bank.
왘 Press the set button
6 to store your setting.
왘 Use the UP button
3 or DOWN button 4 to select a channel.
왘 Press the set button
6 to store your setting.
SCAN menu item
Pressing the set button
6 to activate the SCAN menu item automatically selects an
unused channel.
To select another frequency bank:
왘 Press the UP button
3 or DOWN button 4.
왘 Press the set button
6 to store your setting.
Synchronizing a transmitter with the receiver
The receiver always transfers the frequencies to the transmitter.
왘 Switch the transmitter and the receiver on.
왘 Keep the button 7 of your transmitter pressed until the SYNC display M flashes
on the receiver’s display panel.
왘 Press the button
5 of the receiver to transfer the selected frequency to the
transmitter.
Adjusting the squelch threshold
Interference of the RF signal due to other transmission links can be eliminated as follows:
왘 Switch the transmitter off. The receiver should no longer receive a signal.
왘 If the receiver still receives a signal, use the rotary switch for squelch threshold “SQ”
B
to increase the squelch threshold so that the signal will no longer be received. If the
signal cannot be eliminated in this way, set the transmitter and the receiver to a dif-
ferent channel.
왘 Switch the transmitter on again and check if the receiver receives the transmitter
signal.
You can also synchronize a switched-off transmitter with the receiver. The trans-
mitter automatically switches on during the synchronization process.
If the squelch threshold is adjusted too high, the transmission range will be reduced.
Therefore, always adjust the squelch threshold to the lowest possible setting.