Instruction manual - XS Wireless Digital

Operation

Switching on the transmitter and receiver

Switching on the receiver:

►

▷ Connect the receiver to the power supply system. You can use the in-

cluded power supply unit or power the receiver via the USB port. Bat-

tery operation is not possible.

The status LED starts flashing green. The flashing indicates that a wire-

less connection is being established.

Switching on the transmitter:

►

▷ Briefly press the button on the transmitter.

The status LED indicates the charge level for four seconds.

▷ During these four seconds, check that the transmitter is sufficiently

charged.

> 75 %

5 % – 75 %

< 5 %

If the status LED remains red, you should charge the rechargeable bat-

tery first. If the status LED flashes red, the charge level is too low. You

must charge the rechargeable battery first (see „Charging the re-

chargeable battery“).

After four seconds, the status LED starts flashing green. The flashing

indicates that a wireless connection is being established.

The status LEDs remain green once the transmitter and receiver are

connected. If the status LEDs do not remain green, either the charge

level is below 15 % (see „Checking the charge level during use“) or the

transmitter and receiver are not paired (see „Pairing“).