Instruction manual - XS Wireless Digital

Operation
45
Pairing
The transmitter and the receiver of a set are pre-paired at the factory and
therefore ready for immediate use. The wireless connection is established
once the transmitter and receiver are switched on and within range of each
other.
You can pair up to four transmitters with the receiver. However, you can
only use one transmitter with the receiver at a time. The other paired trans-
mitters must be switched off during this time.
▷ Make sure that both the transmitter and receiver are switched off.
►
▷ Press and hold the pedal switch on the receiver.
▷ Connect the receiver to the power supply system while continuing to
hold the pedal switch until a “P” appears on the display.
The LED will also begin to flash red and green in alternation.
►
▷ Press the button on the transmitter until the status LED starts flashing
green and red in alternation.
The status LEDs will remain green once the transmitter and receiver
are paired and connected. If the status LEDs do not remain green, the
charge level is below 15 % (see „Checking the charge level during use“).
Out-of-range monitoring
The status LEDs begin flashing red when the transmitter and receiver are
almost out of range.
Correcting faults
If the status LED remains red, a fault has occurred.
▷ Unplug any connected USB cables from the UBS port.
▷ Switch the transmitter and receiver off and on again.
▷ Perform pairing, if necessary.
▷ If this does not correct the fault, please contact Sennheiser customer
service:
www.sennheiser.com/service-support